MGR-DTYF2270AEG
Single Phase AC Closed Loop Feedback Solid State Voltage Regulator Module
MGR-DTYF Series
Voltage Power Regulator
MGR-DTYF Series Single Phase Closed Loop Feedback Solid State Voltage Regulator Module (also known as single phase negative feedback voltage regulator, single phase closed-loop negative feed solid state voltage regulator module) is a device with voltage regulation function and voltage...
More
Basic Parameters
Control Signal: E: CON 0~5V; G: CON 4~20mA
Load Voltage: Single phase 220VAC / 380VAC
Load Current: 70A
Dimensions: 105mm*75mm*33mm
Mounting: Panel mount
Features
No external +12V DC power supply required
Effectively stabilize voltage fluctuations with closed-loop (negative feedback) voltage regulator system
Insulation voltage greater than 2000VAC
Support automatic control mode (control signal 4-20mA, 0-5V) and manual control mode, and both modes are smooth to adjust
Built-in shielding circuit with strong anti-interference ability
High-power thyristor chip, and insulating base plate with DCB ceramic glaze material
Stable performance and high reliability
Notice
If the load current is 10A, a heat sink must be equipped; if the load current is 40A or more, an air-cooled radiator or a water-cooled radiator must be installed.
When the load is an inductive load, be sure to connect a varistor in parallel with the output terminal, whose voltage value is 1.6-1.9 times the load voltage.
* Please contact us if you need to customize according to your special needs.
Get in touch with us now!
Please take a minute or two to complete this simple form to get reply in 24 hours, thank you!
*Please check the trash box of your mailbox, if you do not receive our email.
