MGR-DT2240EG
Full Isolation Single Phase AC Solid State Voltage Regulator Module

Control Signal:  E: CON 0~5V; F: CON 0~10V; G: CON 4~20mA; H: CON 1~5V

Control Current:  Low input current, ≤20mA

Power Voltage:  Single phase 220VAC / 380VAC

Load Current:  40A

Dimensions:  105mm*75mm*33mm

Mounting:  Panel mount

Integrates the synchronous transformer, the phase detection circuit, the phase-shift trigger circuit and the thyristor output circuit.

Ordinary Type (one TRIAC as the output component), Enhanced Type (a pair of reverse-parallel SCR as the output component) and Half-wave Type (one SCR as the output component).

Various control signals for selection

E, F, H types can be controlled by the manual control circuit, G type cannot be adjusted with the potentiometer

The speed control of the single phase AC asynchronous motor should be adjusted by the frequency converter, while the single phase voltage regulation module can only be applied to fan motors and pump motors where the requirements are not high.

It is not possible to use three single phase voltage regulator modules to regulate the three phase load on the three phase power grid.

The insulation voltage between the strong current part, the weak current part, and the module backplane is greater than 2000VAC.

The heat of the whole module = Actual load current (Amps) * 1.5 W/Amps. Customers can select MG-L, MG-H series heat sink according to actual needs.